The NuSLEEVE 5440 I* is a fire break that can be used to protect mechanical penetration assemblies in composite tubes.
* Also named "Compensateur 200N"
Product Data
- Silicone-coated fabric
- Enables up to 25 mm pipe displacement with no deterioration of the seal or fire break
- Resistant to water pressure up to 0.15 bar
- Acts as a fire break for up to two hours depending on configuration
- Cold welding installation on preinstalled piping
- Adapted to 200 mm composite pipes
Operational Information
- The NuFP 4110 F Sleeves (335.S) are to be located between the concrete slab and the composite tube on each side of the slab. The sleeve is then fit around the composite tube and assembled by cold welding with NuFP 4110 F \ (335.S). The sleeve is then glued to the surface of the tube with the NuFP 4110 F (335.S) Adhesive. The peripheral part of the sleeve is to be fixed to the concrete and the composite tube with the NuCOAT 3210 I (75.N) Putty. Finally, the sleeve is screwed into the concrete slab.
Other Technical Information (Packaging, Storage)
- Film-wrapped
- Storage temperature: 5°C to 50°C (40°F to 120°F)
- Product shelf life: Unlimited
ADDITIONAL INFORMATION
- Acts as a fire break for up to two hours depending on configuration
System Options
References
- 1998 — CNPE Civaux (France): 100 units
